Metal lips and epoxy

[Rockfish9]

I've done it both ways, witht he set up I have it works out much better to assemble then epoxy... the exception being jointed plugs, I do them in two pieces, the front section is epoxied/assembled, the rear sectioin is secured with wire to my spinner then assembled latter..

[Rockfish9]

I've shown mine here before, this is the top half... it can handle 18 8" plugs... and runs on a timer... like ronco , set it and forget it... the bottom half turns plugs in line and can handle 6 8" plugs.... both are geared to run @ 3 RPM..