Removing Guides...

[numbskull]

I cut off guides (slice along one side of each foot on a tangent to the blank then push the guide over sideways) with a razor blade, unwind any thread left on the blank (which will take the overlying epoxy with it), then soften any epoxy left on the blank with a heat gun (got the idea from the Fuji website) and it will peel right off. The melting point of the epoxy is way below that of the blank, just don't go nuts. It is also a very good way to remove the mounting under a reel seat once you cut the seat off with a dremel.

[junkmansj]

PLEASE do not use a Dremel tool to remove guides! as suggested use a razor knife or blade lay it almost flat on top of the guide foot cutting toward the guide. Remove the old finish and thread ,remove guide and you can pick or unwind the old thread. then scrape old finish off with a Plastic knife or or old credit card. Be care full with heat. Do not over heat the blank

[nightfighter]

I was only suggesting using the dremel on the broken rod from which he was salvaging the guides.....

[Swimmer]

If you were going to do over the rod that you are stripping guides from it can be a very touchy job. Since you are tossing the blank I wouldn't worry about it. A suggestion though and that is to practice on the broken blank as if it were going to be reused, and that way if you ever need to strip a blank in the future you'll be good to go.

I usually use a four inch wide razor scraper. They are sold for stripping wallpaper and other stuff. You can get a good strong grip with it though, so that the blade will run along the blank just under the epoxy covering the guides at an angle which makes quick work of the task. You can take just a little or as you gain more experience more by creating more inward pressure on the tool. Then lightly scrape or sand (600 grit, wet) the residue with a new blade until the blank is smooth.

[junkmansj]

the Dremel would probably damage the guide feet. Guess I missed the part about the Rod being Broken. sorry