Quote:
Originally Posted by Diggin Jiggin
I also turned some darters but haven't gotten to the point where I screw them up yet.
|
Don't scew them up ... take some time and make a sled ... Take one of those blanks and rip it in half . Lay it on a block of wood like a darter blank and trace ,(bandsaw),leave some stock in the back (arse of plug).. mark where you want your belly hole .. On sled drill out belly hole and glue in a 3/8 dowel there or whatever you, you use for a belly hole .. In back of sled drill hole where the arse hole of plug is .. Now pre drill belly/arse of blanks ,, slip belly hole of blank over the dowel and screw the arse with and 1.5 drywall screw .. Blank should be held firmly in the sled so you can make square cuts at 90 degrees ..(bandsaw),, Make a pattern ,, trace darter profile,, leave a little line .. touch up beltsander to line ..
Threaded Mode