|
Spook nose grommet problem!
Well I turned some spook style baits and ran into a little problem. I drilled the spooks off center so that the line tie would be lower than the nose of the bait. My problem is that when I assembled the baits with the thru wire the 3/16" nose grommet will not sit flush with the slope of the line tie location. On the top side it sits fine on the underside it sticks out off the bait profile. Can I just scrap the nose grommet and thru wire without it and just fill the cavity with epoxy?
Thanks in Advance!!
|
Threaded Mode