Is this the Place?

[numbskull]

Originally Posted by Diggin Jiggin

Good morning everyone... I'm jealous of what you guys already have going. I haven't gotten to work any plug stuff yet, its hard for me to get to it before the holidays but I have a few hours to play this afternoon. I've been meaning to experiment a bit with the musso swimmer shapes but I don't have anything to work from. Can someone post some basic length width dimensions ?

Much about these has been posted previously. Here are some details on the 6" Musso pine I measured (but no longer have). If you are interested in the big swimmers pm me, or better yet come by Falmouth this week and I can show you what I know.

Here are the details on the pine jr I sent ******. The size of weight is in there.

The junior musso I measured was a pine.
it is 6 1/8" long
.85" at the nose
.5" at the tail
widest spot was 3" from the nose and measured 1.3" wide
the weight was also 3" from the nose and is 3/8" diameter and 3/4" height....drilled through
first hook is 1.25" from nose, second hook 4"
diameter 2" from either end is 1.2" (it is 1.11" at the first hook)
The lip slot is above center on the plug I saw. about .34" from the top of the plug to the slot.
The plug weighed 2.5oz, but I don't recall if this was rigged or not

I suspect the lower lip slot position that appears to be used on some plugs I've seen on line (I've never actually inspected one) was a later change and used primarily in surface swimmers (which I have not built in the Jr size).

The pine uses a high slot lefty 2 lip
The ss presumably uses the mid slot lip
I've not xrayed a maple jr....the maple sr carries a much smaller weight than the pine or ss. I think he just weighted them to float level and low.