More kitchens

[nightfighter]

Been there Trevier... For the hardwoods, like maple crown stock, I have a designated 80T blade and set up a goof proof jig so I don't pooch the spring angle. Of course if the ceiling or plaster is off, well... then it's shim, cut, test fit, shim, cut, test fit, check how much stock I have on site.... And the cabinet manufacturers do not take into account for face frames that run proud of the cabinet's side panel, which is always fun to point out to a fancy kitchen designer that has sold the client on a fancy crown. ("Oh, I have never come across that before...") It's all problem solving boys.
Here's a kitchen I did not long before I had my knee replaced. Designer's plans were off by 3.25 inches on the height. She would not even show her face onsite until the counters were in....