Is this the Place?

[numbskull]

Originally Posted by chrisjoe13

Mistakes I made this time:
-during epoxy sealing, dropped a plug, spilling thinned epoxy all over
-countersunk belly grommets a little too deep
-dropped (more than one) on cement floor after paint but before clear coat
-scratched tail end of a few while doing tailwraps
-dropped one while 'flipping', had 6" dust bunnies on it when I picked it up
-some tail wraps look good, others look like I've never seen one before
-painted over some scales by mistake (there is a one side scaled plug)
-and of course the mandatory abundance of dust and bubbles!

Bah.........you have a ways to go yet.

You still need to glue the cards into the lip slot (plastic works best), forget to mix in the hardner when you coat a dozen plugs, get so much epoxy in the hook hole you can't get the turning rod out, have the spinner/shaft connection come loose so it all sags instead, and set the epoxy on fire while flaming bubbles.

Then there is the split your plug while wiring bit, split your plug while forcing in the belly weight bit, drill your hook hole through the darter slope trick, drill your hook holes on the wrong side of the plug, epoxy in the wrong lip, sand the diving slope on the wrong side, drill the wrong size eye holes, drill the wrong size grommet holes, and cut the lip slot too thick a kerf.

Then for paint there is the spray your plug with air brush cleaner thing, forget to clean between colors thing (love those pink bellies), bubble off the paint with the heat gun thing, and my very favorite the GIANT eye spot blot trick.

Ugh.