|
17", 3/4 hp, 1996 International Drill Press
Floor Drill Press. Works well. Given to me but I have no use for it. Looks like the model in the picture, except the table is round instead of square.
This is a no-BS, all-metal, 5/8" chuck press.
Flaws:
1. The exposed metal on the table and base have surface rust on them (no real pitting). Looks like they would clean-up well with a wire brush.
2. No chuck key.
3. The handle to crank the table up & down was broken in transport. I have the pieces. Looks like a low-cost fix.
$140 firm. Buyer has to pick it up in Seabrook, NH.
Last edited by Eric Roach; 01-04-2010 at 02:25 PM..
|
Linear Mode
