Quote:
Originally Posted by nightfighter
It doesn't take much to be "#^&#^&#^&#^& by just an RCH and have to work at getting the thread to screw in straight from a buggered hole shot. The design of this one is not far off from being good. Just get aluminum instead of plastic for the body and to thread into. And then add an additional set of holes in line with the drill guide holes and fasten the handle to those holes. That would guarantee the correct distance between the holes... Then the only thing you could mess up is centering or height....
Today's "Really?" moment was installing new grab bars in an elderly couple's shower, toilet, and garage stairway. I ordered some 18'" and some 12" off of the river site... (I know) One 18" bar had been previously used!!!! Full refund via internet... This country, if not the world has just gone to chit.
I am assuming I dont have to translate "RCH"....
|
that is disgusting, yes world has gone to chit, globalization will finish it off if they get their way.