Been working nights so it's been nice from the standpoint of waking up and working on the boat during the work week without interrupting family time.
I fixed my own error in the panel this morning by printing a circle to scale of my Tachometer/engine monitor guage and carefully using a dremel on the panel material with a router plate on it by recessing the back. Snug fit. I'm going to use the horseshoe shaped bracket to create a secure mount by bending the bottom 1/2" or so outwards, drilling them out and use epoxy to set bolts into the backside of the panel. Let it cure with the bolts in place for a few days then tighten up the bolts.
Posted from my iPhone/Mobile device
|