View Single Post
Old 01-11-2007, 11:58 AM   #27
Bernzy
Registered User
iTrader: (0)
 
Bernzy's Avatar
 
Join Date: Jul 2002
Location: Indianapolis, IN
Posts: 1,269
I went through the same thing when I bought my bandsaw.

You have 2 sets of guide blocks, one set is above the table the other set is below. You need to loosen the machine screws on both sets and push the blocks in towards the blade. You want the space between the blocks and the blade to be about the thickness of a dollar bill.
Also, you have 2 thrust bearings that face the back of the blade. One is above the table, the other is below. You want to push them in towards the back of the blade, close but not touching.

I hope this helps.

Bernzy

"Sometimes you eat the bear and, well, sometimes... the bear, he eats you." _____________________
Support your S-B sponsors
--------------------------------------
Bernzy is offline   Reply With Quote