|
Turns out I do have one but have not xrayed it.
It is the same body as the conrad jr. I can't see a weight hole and suspect it is maple, but it weighs the same as a conrad Jr (2.50z rigged) and the conrads are often pine with a big weight. It floats the same (level with the water line about 1/8" below the back).
The line tie slot is .25" down. The lip itself is a bit wider than the conrad I have (1.17 vs 1.10) but that is likely not intentional.
The slope angle is roughly 67 degrees. It starts a fraction above the lip slot and ends about 1 1/8" back.
|