Spray Booth questions
 

Where has anyone here bought a spray booth? Any recommendations.

They all seem over priced for what could easily be made. I just changed out of fans in mine as one of them died but it was my fault.
Posted from my iPhone/Mobile device

build one frank. use pasche as a model, not hard at all. use a draft blower fan which you can isolate fumes if using anything flammable.

http://vent-works.com/blogs/the-vent...by-spray-booth

If I were to build another I'd build this. That blower is on eBay for $82 bucks.

I've seen some nice set ups in totes as well.
Posted from my iPhone/Mobile device

I built one very similar to that design out of 1/2 plywood. Can whip that up in a jiffy, Frank. You just need to pick your dimensions. Let me know.

Thanks fellas
Posted from my iPhone/Mobile device

I can put that together. I will look at that motor tomorrow, and probably order it. Thanks eskimo.
Posted from my iPhone/Mobile device

I bought one years ago. Def build one and get a good fan. You will not be missing anything.
Posted from my iPhone/Mobile device

The fan I've been using is from a Jenn air down draft stove. You can find them on Craigslist or ebay. You can get a control that changes the speed, I don't use the control though.

I do need to make a new booth. Thanks for sharing the vent works design Eskimo!!!

this is the one I modeled mine after. http://www.usartsupply.com/PASBBF-3-...w#.VsByc4-cEu4

Don is that good for solvent based paints too, fan wise?
Posted from my iPhone/Mobile device

Ordered Eskimo's motor suggestion. I have 1/2 plywood stock down cellar from a wood bin disassemble I did. Have to look around for metal stock??????

Make it out of plywood.....

I used plywood and copied their design but used a 350 cfm fan/blower. the motor i used is totally isolated from fan and spray.

Thanks.
Posted from my iPhone/Mobile device